|
|
PA5XD |
|
|
|
ULTRA HIGH POWER
ONE-PIECE PA SYSTEM/POWERED MONITOR
POUND FOR POUND THE WORLD’S MOST POWERFUL SOUND SYSTEM
|
 The Powered Hot Spot Monitor is a product like no other.
The Powered Hot Spot delivers an ear shattering
100 watts of power! The Powered Hot Spot, like the
original Hot Spot, delivers high power, in a small,
portable, lightweight design, about the size of a
shoe box. The Powered Hot Spot contains one of
Galaxy Audio's NEOLITE Neodymium driver.
Inside the Powered Hot Spot is a power amp
that can deliver 100 watts continuously @ 8
ohms, 150 watts @ 4 ohms. The Class H
power supply configuration utilizes four
output transistors, a low voltage pair and
a high voltage pair. Its low voltage
transistors are active with any signal.
When demand on the amp exceeds the low
voltage transistors' capabilities, the high voltage
transistors kick in and provide additional power.
The result is an amplifier that runs cooler, weighs less,
is smaller and more efficient. The Powered Hot Spot contains
two inputs, a ¼” and an XLR, each with its own volume control.
Both inputs feature the ability to accept microphone or line level
input, which maximizes the signal-to-noise ratio of virtually any
input source. Best of all, you don't have to flip a switch to distinguish
between microphone or line level, the Powered Hot Spot automatically
adjusts itself with our SmartALIC circuitry. Also, the Powered Hot
Spot features a 3-band equalizer to allow you to adjust the equalization
for optimum sound. As well as the built-in compressor/limiter circuitry
controls the amplifier gain, acting like a compressor on transient signal
and a “brick wall” limiter on signals that continuously exceed a
predetermined limit. This results in an apparent 6 dB increase in SPL without distortion. That's twice the sound pressure! The Powered Hot
Spot produces a maximum SPL of 114dB. That's more sound pressure
level than most sound systems twice it size! The Powered Hot Spot is
constructed of a black fire-retardant styrene with a black cast aluminum
faceplate/grille, which is attractive and act as a heat dissipation device.
With the Powered Hot Spot containing the lightweight NEOLITE Neodymium driver and a 150 watt power amplifier, it is truly “POUND
FOR POUND THE WORLD'S MOST POWERFULL SOUND SYSTEM”!
|
|
SPECIFICATIONS
|
AMPLIFIER SECTION:
|
| Rated Power: |
146 watts @ 4 ohms, 100 watts @ 8 ohms
|
| Equalization: |
Three band center detent
Lo: ± 10 dB peak/dip at 300 Hz
Mid: ± 10 dB peak/dip at 2 kHz
Hi: ± 12 dB shelving at 15 kHz
|
| Frequency response: |
200 Hz–20 kHz
|
| Signal-to-Noise Ratio: |
>95 dB
|
| Total Harmonic Distortion: |
<0.05% @ 4 ohms, <0.1% @ 8 ohms
|
| Minimum Recommended Load Impedance: |
4 ohms
|
| Input Sensitivity for 8 ohm power: |
1 VRMS IHF Damping Factor: >380
|
| Input connections: |
(each with individual volume control): One¼" balanced One XLR balanced, with +24 VDC phantom power
|
| Output connections: |
One ¼-inch speaker level for minimum
8 ohm load. One (post-EQ, post-level) RCA line out
|
| Indicator LEDs: |
POWER, COMPRESSOR-LIMITER
|
| Power Requirements; Domestic: |
120 VAC 60Hz
|
| Export: |
230VAC 50Hz
|
| Safeguards: |
Short circuit current limiting. Short circuit foldback
limiting. Thermal short circuit protection. Dynamic load line cooling.
Turn on/turn off transient suppression
|
| SPEAKER SECTION: |
| Speaker: |
One Galaxy Audio S5N-8 ferro fluid cooled
5” NEOLITE Neodymium driver.
|
| Nominal impedance: |
8 ohms
|
| Power handling capacity: |
100 watts @ 8 ohms
|
| Sensitivity (I Watt @ 1 meter): |
92 dB (1 kHz octave band)
|
| Frequency response: |
150 Hz–18 kHz
|
| Maximum SPL @ clip (100 Watts @ 1 meter): |
114 dB
|
| SPLOWT: |
10.7
|
| Enclosure Materials: |
Fire retardant styrene
|
| Color: |
Black case with black cast aluminum grille
|
| Dimensions: |
6.75" x 10.94" x 6" (171 mm x 278 mm x 152 mm)
|
| Net weight: |
10.7 lbs. (4.9 kg)
|
| Shipping weight: |
11.7 lbs. (5.3 kg)
|
|
|
| |
|
ARCHITECT AND ENGINEER SPECIFICATIONS
The
PA system shall be a portable integrated unit featuring an amplifier,
two-channel mono mixer with phantom power, equalizer, compressor and a
single loudspeaker. The amplifier shall be capable of producing 146
continuous watts of power to a 4 ohm load, 100 watts of continuous
power to the internal 8 ohm speaker. The mixer section shall include
one balanced (differential) input using a 14-inch phone plug connector
and one +24 VDC phantom powered balanced (differential) input using an
XLR connector. The mixer section shall include two separate sensitivity
controls capable of automatically adjusting the gain to handle line,
instrument or mic level inputs and a RCA connector capable of line
level output. Equalization shall be accomplished via a three band
equalizer: ± 10 dB peak/dip at 300 Hz, ± 10 dB peak/dip at 2 kHz, ± 12
dB shelving at 15 kHz. The PA system shall have a 14-inch speaker level
output jack capable of driving an 8 ohm load. The internal loudspeaker
shall be a Neodymium ferrofluid cooled 5-inch full range driver.
Sensitivity measured at 1 watt at 1 meter (1 kHz. octave band) shall be
98 dB. The enclosure shall be constructed of fire retardant styrene
with fade-resistant colors. The cabinet finish shall be black with a
black cast aluminum bezel. Dimensions shall be 6 inches (152 mm) high,
10.94 inches (278 mm) wide and 6.75 inches (171 mm) deep. The system
weight shall be 10.7 lbs (4.9 kg). The PA system shall display UL, CSA
and CE agency markings. The PA system shall be the Galaxy Audio PA5XD.
|
|
Shop 
